CANOGA PERKINS 9171 Command Reference - Manual (Page 719)

CanogaOS Command Reference
40-48
show boot
40.65 clear logging buffer
To clear messages from the logging buffer, use the clear logging buffer command in global
configuration mode.
Command Syntax
clear logging buffer
Command Mode
Global configuration
Usage
Examples
The following is sample output from the clear logging buffer command.
Switch(config)# clear logging buffer
Related Commands
show logging buffer
40.66 logging alarm-trap
To limit messages logged to the syslog servers based on severity, use the logging alarm-trap
command in global configuration mode. To restore the default level, use the no form of this command.
Command Syntax
logging alarm-trap {enable | disable | level {high | lower | middle | minor} }
no logging alarm-trap level
enable Enable logging traps.
disable Disable logging traps.
high The high alarm level.
lower The lower alarm level.
middle The middle alarm level.
minor The minor alarm level.
Command Mode
Global configuration
Default