CANOGA PERKINS 9171 Command Reference - Manual (Page 321)

CanogaOS Command Reference
18-2
destination-ip-address Destionation ip address of sending icmp packet;
destination-hostname Destionation hostname of sending icmp packet;
Command Mode
Ipsla mode
Defaults
none
Examples
In the following example, the type echo protocol ipIcmpEcho command is used to set icmp
packet and destination ip address:
Switch(config)#ip sla monitor 1
Switch(config-ipsla)# type echo protocol ipIcmpEcho 192.168.0.1
Related Commands
show ip sla monitor
18.3 FREQUENCY
Sets the rate at which a specified IP SLA operation repeats.
To turn to default value, use no form of this command.
Command Syntax
frequency seconds
no frequency
Syntax Description
seconds Time range is from 1 to 4800.
Frequency • timeout • threshold
Command Mode
Ipsla mode
Defaults
Default value is 60 seconds.
Examples
In the following example, the frequency command is used to set the rate at which a specified IP
SLAs operation repeats:
Switch(config)#ip sla monitor 1
Switch(config-ipsla)# frequency 10
Related Commands