CANOGA PERKINS 9171 Command Reference - Manual (Page 226)

CanogaOS Command Reference
15-17
ip ospf dead-interval 20
Related Commands
ip ospf hello-interval
show ip ospf interface
15.19 ip ospf disable all
To disable al the OSPF functionality on an interface, use the ip ospf disable all command in interface
configuration mode. To restore the OSPF functionality, use the no form of this command.
Command Syntax
ip ospf disable all
no ip ospf disable all
Default
OSPF functionality is enabled.
Command Mode
Interface configuration
Usage
Examples
The following example disables the OSPF functionality on interface eth-0-1:
interface eth-0-1
ip ospf disable all
Related Commands
15.20 ip ospf hello-interval
To specify the interval between hello packets that the switch sends on the interface, use the ip ospf
hello-interval command in interface configuration mode. To return to the default time, use the no form
of this command.
Command Syntax
ip ospf hello-interval seconds
no ip ospf hello-interval
seconds Specifies the interval (in seconds). The value must be the same for all nodes on a
specific network. The range is from 1 to 65535.