CANOGA PERKINS 9171 Command Reference - Manual (Page 325)

CanogaOS Command Reference
18-6
Examples
In the following example, the show ip sla monitor command is used to show ip sla monitor
entries:
Switch#show ip sla monitor
Entry 1
Type : Echo
Admin state : Enable
Destination address : 192.168.0.1
Frequency : 3 seconds
Timeout : 2 seconds
Threshold : 1seconds
Running Frequency : 3 seconds
Vrf : vpn1
Return code : OK
Related Commands
Ip sla monitor;
18.9 TRACK INTERFACE LINKSTATE
Create a track object and track the state of an interface, use the track
interface linkstate to command in global configuration mode. To remove a
track, use the no form of this command.
Command Syntax
track objectid interface IFNAME linkstate
no track objectid
Syntax Description
Objected Object identity is used to identify track object, its
range is from 1 to 500;
Command Mode
Global configuration
Defaults
none
Examples
In the following example, the track interface linkstate command is used to create an track
object:
Switch(config)#track 1 interface eth-0-1 linkstate