CANOGA PERKINS 9171 Command Reference - Manual (Page 154)

CanogaOS Command Reference
9-6
Examples
Switch (config-if)# switchport trunk vlan-translation vlan mapping table vlantranstable
Related Commands
show vlan mapping table
9.11 dot1q ethertype
Use this command to dot1q ethertype.
Command Syntax
dot1q ethertype VALUE
VALUE: the ethertype value, could be 0x0000 ~ 0xFFFF
Command Mode
Interface configuration
Usage
Use this command to configure dot1q ethertype for switchport.
Examples
This example show how to configure eth-0-1’s ethertype to 0x88a8
Switch(config-if)# dot1q ethertype 88a8
Related Commands
None
9.12 l2protocol-tunnel enable
Use this command to enable l2protocol tunnel globally.
Command Syntax
L2protocol-tunnel enable
Command Mode
Interface configuration
Usage
Use this command to enable l2protocol tunnel globally.
Examples
This example shows how to enable l2protocol globally.
Switch(config)# l2protocol-tunnel enable
Related Commands
show l2protocol-tunnel