CANOGA PERKINS 9171 Command Reference - Manual (Page 174)

CanogaOS Command Reference
11-2
11.2 ethetnet oam mode
Use the command to configure Ethernet OAM mode on an interface
Command Syntax
ethernet oam mode active
ethernet oam mode passive
no ethernet oam mode
Command Mode
Interface mode
Default
The default Ethernet OAM mode for the DTE is passive.
Usage
This command is used to set the DTE to active mode or passive mode.
Examples
Switch # configure terminal
Switch (config)# interface eth-0-1
Switch (config-if)# ethernet oam mode active
Switch (config-if)# ethernet oam mode passive
Related Commands
11.3 ethernet oam min rate
Use this command to set the OAMPDU timer. Use the no form of the command to reset to
default value.
Command Syntax
ethernet oam min-rate SECONDS
no ethernet oam min-rate
SECONDS the number of seconds chosen for this timer in the range <1-10>
Command Mode
Interface mode
Default
The default value of the OAMPDU timer is 1 second.