CANOGA PERKINS 9171 Command Reference - Manual (Page 462)

CanogaOS Command Reference
26-4
Command Mode
Configure mode
Defaults
This command has no default settings.
Exa m ples
In the following example, the mpls lsp-tunneling command is used to specify
one ILM to tunnel:
Switch# configure terminal
Switch(config)# mpls lsp-tunneling 100 300 200.200.200.0/24
Related Commands
no mpls lsp-tunneling
26.6 no mpls lsp-tunneling
Use this command to remove one ILM from using a tunnel.
Command Syntax
no mpls lsp-tunneling INLABEL
Syntax Description
INLABEL Incoming label, the range is 16 to 1048575.
Command Mode
Configure mode
Defaults
This command has no default settings.
Examples
In the following example, the no mpls lsp-tunneling command is used to
remove one ILM from using a tunnel:
Switch# configure terminal
Switch(config)# no mpls lsp-tunneling 100
Related Commands
mpls lsp-tunneling
26.7 mpls map-route
Use this command to specify one FEC mapped to a FTN entry.