CANOGA PERKINS 9171 Command Reference - Manual (Page 437)

CanogaOS Command Reference
25-25
Command Mode
Interface mode
Defaults
The default is 15 seconds.
Examples
In the following example, the ldp targeted-peer-hello-interval command is
used to set the interval for sending unicast hello packets to targeted peers via
this interface:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ldp targeted-peer-hello-interval 635
Related Commands
show ldp interface IFNAME
targeted-peer-hello-interval
25.29 ldp targeted-peer-hold-time
Use this command to set the time-out value that is the time that the router waits
before rejecting an adjacency with a targeted peer. Use the no parameter to
revert to the targeted-peer value set for the main LDP process.
Command Syntax
(no) ldp targeted-peer-hold-time number
Syntax description
number Specifies the interval in seconds, the range is 3
to 65535
Command Mode
Interface mode