CANOGA PERKINS 9171 Command Reference - Manual (Page 528)

CanogaOS Command Reference
29-10
29.14 no mpls-vpls
Use this command to unbind an interface to a VPLS instance.
Command Syntax
no mpls-vpls NAME [vlan VLANID]
Syntax description
NAME Identifying string for VPLS instance
VLANID Vlan identifier, the range should be from 1 to
4094.
Command Mode
Interface mode
Defaults
This command has no default settings.
Examples
In the following example, the no mpls-vpls command is used to unbind an interface to a
VPLS instance:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# no mpls-vpls vpls1
Related Commands
mpls-vpls
29.15 clear mpls vpls mac-addresses
Use this command to remove MAC addresses that have been dynamically
learned for faster convergence, and this is accomplished by sending an LDP
Withdraw Message to all other PEs over the corresponding LDP session.
Comm a nd Syntax
clear mpls vpls NAME mac-addresses
Syntax description
NAME Clear data for VPLS instance with specified
name.
Command Mode
Privileged EXEC mode