CANOGA PERKINS 9171 Command Reference - Manual (Page 658)

CanogaOS Command Reference
39-5
39.6 more
To display the contents of a file, use the more command in EXEC mode.
Command Syntax
more [flash:/directory-name/]file-name
flash: The flash system
directory-name The directory in flash:
file-name The file name.
Command Mode
EXEC
Usage
The system can only display a file in ASCII format.
Examples
The following partial sample output displays the configuration file named startup-config in flash:
Switch# more flash:/startup-config.conf
!
no service password-encryption
!
!
hostname Switch
!
!
!
diagnostic bootup level minimal
management ip address 192.168.0.1/24
!
Related Commands
dir
ls
39.7 mkdir
To create a new directory in a Flash file system, use the mkdir command in EXEC mode.
Command Syntax
mkdir directory-name
directory-name The directory in flash: