CANOGA PERKINS 9171 Command Reference - Manual (Page 534)

CanogaOS Command Reference
30-3
20000.Default is 2.
repeat
REP_VAL Specifies the number of times to resend a
packet. The range is from 1 to 5000. Default is
5.
reply-mode
MODE Specifies the reply mode for the echo request
packet.
z Reply with IP UDP packet (default)
z Reply with IP UDP packet with router alert
timeout
TIME_OUT Specifies the timeout interval in seconds. The
range is from 1 to 500. Default is 60.
ttl TTL_VAL Specifies the TTL value to be used in the
MPLS labels.
The range is from 1 to 255. Default is 255.
Command Mode
Privileged Exec mode
Defaults
This command has no default settings.
Examples
In the following example, the ping mpls l2-circuit command is used to initiate
sending MPLS echo request packets in the specified Layer-2 Virtual Circuit
(VC) of the MPLS cloud.
Switch# ping mpls l2-circuit 100 source 10.10.10.10 destination 127.0.0.1 dsmap
detail flags interval 100 repeat 100 reply-mode timeout 100 ttl 200
Related Commands
30.3 traceroute mpls l2-circuitping mpls l3vpn
Use this command to initiate sending MPLS echo request packets in the
specified VPN instance of the MPLS cloud.
Command Syntax
ping mpls l3vpn VRFNAME A.B.C.D/M source A.B.C.D [destination
A.B.C.D | detail | dsmap | flags | interval INT_VAL | repeat REP_VAL |
reply-mode MODE | timeout TIME_OUT | ttl TTL_VAL]
Syntax Description
VRFNAME Layer-2 VC ID.
A.B.C.D/M BGP VPN prefix.
source A.B.C.D Specifies the source address used in the echo