Dell POWEREDGE M1000E - Manual (Page 988)

988 Configuring OSPF and OSPFv3
area area-id virtual-link
router-id [authentication
[message-digest | null]]
[[authentication-key key]
| [message-digest-key key-
id md5 key]]
Create the OSPF virtual interface for the specified area-
id and neighbor router.
Use the optional parameters to configure authentication
for the virtual link. If the area has not been previously
created, it is created by this command. If the area already
exists, the virtual-link information is added or modified.
• authentication—Specifies authentication type.
• message-digest—Specifies that message-digest
authentication is used.
• null—No authentication is used. Overrides password or
message-digest authentication if configured for the
area.
• md5—Use MD5 Encryption for an OSPF Virtual Link
•
key—Authentication key for the specified interface.
(Range: 8 bytes or less if the authentication type is
simple and 16 bytes or less if the type is encrypt.)
• key-id—Authentication key identifier for the
authentication type encrypt. (Range: 0-255)
area area-id virtual-link
neighbor-id retransmit-
interval seconds
Set the OSPF retransmit interval for the virtual link
interface.
The
seconds variable is the number of seconds to wait
between retransmitting LSAs if no acknowledgement is
received. (Range: 0–3600)
area area-id virtual-link
neighbor-id hello-interval
seconds
Set the OSPF hello interval for the virtual link.
The
seconds variable indicates the number of seconds to
wait before sending Hello packets from the virtual
interface. (Range: 1–65535).
area area-id virtual-link
neighbor-id dead-interval
seconds
Set the OSPF dead interval for the virtual link.
The
seconds variable indicates the number of seconds to
wait before the virtual interface is assumed to be dead.
(Range: 1–65535)
Command Purpose