Dell POWEREDGE M1000E - Manual (Page 986)

986 Configuring OSPF and OSPFv3
Configuring Stub Areas and NSSAs
Beginning in Privileged EXEC mode, use the following commands to
configure OSPF stub areas and NSSAs.
network ip-address
wildcard-mask area area-
id
Enable OSPFv2 on interfaces whose primary IP address
matches this command, and make the interface a member
of the specified area.
• ip-address — Base IPv4 address of the network area.
• wildcard-mask — The network mask indicating the
subnet.
• area-id — The ID of the area (Range: IP address or
decimal from 0–4294967295).
exit Exit to Global Config mode.
exit Exit to Privileged EXEC mode.
show ip ospf interface
[vlan vlan-id]
View summary information for all OSPF interfaces
configured on the switch or for the specified routing
interface.
show ip ospf interface
stats vlan vlan-id
View per-interface OSPF statistics.
Command Purpose
configure Enter global configuration mode.
router ospf Enter OSPF configuration mode.
area area-id stub Create a stub area for the specified area ID.
area area-id stub no-
summary
Prevent Summary LSAs from being advertised into the
stub area.
area area-id default-cost
integer
Configure the metric value (default cost) for the type 3
summary LSA sent into the stub area. Range:
1–16777215)
area area-id nssa Create an NSSA for the specified area ID.
area area-id nssa no-
summary
Configure the NSSA so that summary LSAs are not
advertised into the NSSA.
Command Purpose