Dell POWEREDGE M1000E - Manual (Page 216)

216 Controlling Management Access
Controlling Management Access (CLI)
This section provides information about the commands you use to control
access to the switch management interface. For more information about
these commands, see the PowerConnect M6220/M6348/M8024/M8024-k CLI
Reference Guide at support.dell.com/manuals .
Configuring a Management Access List
Beginning in Privileged EXEC mode, use the following commands to create a
management access list. There is an implicit deny-all rule at the end of every
management ACL. This means that any host that does not meet the criteria
defined in a permit command is denied access to the management interface.
NOTE: Management ACLs can be applied only to in-band ports and cannot be
applied to the OOB port.
Command Purpose
configure Enter Global Configuration mode.
management access-list
name
Define an access list for management, and enter the
access-list for configuration.