Dell POWEREDGE M1000E - Manual (Page 128)

128 Setting Basic Network Information
Configuring Basic Network Information (CLI)
This section provides information about the commands you use to configure
basic network information on the PowerConnect
M6220/M6348/M8024/M8024-k switch. For more information about these
commands, see the PowerConnect M6220/M6348/M8024/M8024-k CLI
Reference Guide at support.dell.com/manuals .
Enabling the DHCP Client on the OOB Port
Beginning in Privileged EXEC mode, use the following commands to enable
the DHCP client on the OOB port.
Enabling the DHCP Client on the Default VLAN
Beginning in Privileged EXEC mode, use the following commands to enable
the DHCP client on the default VLAN, which is VLAN 1.
Command Purpose
configure Enter Global Configuration mode.
interface out-of-band Enter Interface Configuration mode for the OOB port.
ip address dhcp Enable the DHCP client.
CTRL + Z Exit to Privileged EXEC mode.
show ip interface out-of-
band
Display network information for the OOB port.
Command Purpose
configure Enter Global Configuration mode.
interface vlan 1 Enter Interface Configuration mode for VLAN 1.
ip address dhcp Enable the DHCP client.
ipv6 address dhcp Enable the DHCPv6 client.
CTRL + Z Exit to Privileged EXEC mode.
show ip interface vlan 1 Display network information for VLAN 1.