Dell POWEREDGE M1000E - Manual (Page 1210)

1210 Managing IPv4 and IPv6 Multicast
Configuring and Viewing IGMP
Beginning in Privileged EXEC mode, use the following commands to
configure IGMP on the switch and on VLAN routing interfaces and to view
IGMP information.
Command Purpose
configure Enter global configuration mode.
ip igmp Enable IGMP on the switch.
interface vlan vlan-id Enter Interface Configuration mode for the specified
VLAN.
ip igmp Enable IGMP on the interface.
ip igmp version version Set the version of IGMP for an interface.
The
version variable can be 1, 2, or 3.
ip igmp robustness
robustness
Configure the robustness that allows tuning of the
interface, that is, tuning for the expected packet loss on a
subnet. If a subnet is expected to have significant loss, the
robustness variable may be increased for the interface.
The range for
robustness is 1–255.
ip igmp query-interval
seconds
Configure the query interval for the specified interface.
The query interval determines how fast IGMP Host-
Query packets are transmitted on this interface.
The range for
seconds is 0–3600 seconds.
ip igmp query-max-
response-time seconds
Configure the maximum response time interval for the
specified interface. It is the maximum query response
time advertised in IGMPv2 queries on this interface.
The range for
seconds is 0–25 seconds.
ip igmp startup-query-
interval seconds
Set the interval between general queries sent at startup on
the interface.
The range for
seconds is 0–300 seconds.
ip igmp startup-query-
count count
Set the number of queries sent out on startup —at
intervals equal to the startup query interval for the
interface.
The range for
count is 1–20.