Dell POWEREDGE M1000E - Manual (Page 753)

Configuring L2 Multicast Features 753
Configuring L2 Multicast Features (CLI)
This section provides information about the commands you use to configure
L2 multicast settings on the switch. For more information about the
commands, see the PowerConnect M6220/M6348/M8024/M8024-k CLI
Reference Guide at support.dell.com/manuals .
Configuring Bridge Multicasting
Beginning in Privileged EXEC mode, use the following commands to
configure MAC address table features.
Command Purpose
configure Enter global configuration mode.
mac address-table
multicast filtering
Enable multicast filtering on the switch.
mac address-table
multicast static vlan
vlan-id {mac-multicast-
address | ip-multicast-
address}
Register a MAC-layer Multicast address in the bridge
table.
• mac-multicast-address — MAC multicast address in the
format xxxx.xxxx.xxxx.
• ip- multicast-address — IP multicast address.
mac address-table
multicast static vlan
vlan-id {mac-multicast-
address | ip-multicast-
address} [add|remove]
interface interface-list
Add ports and LAGs to the multicast group as static
members.
• add — Adds ports to the group. If no option is specified,
this is the default option.
• remove — Removes ports from the group.
•
interface-list — Specifies the interface type (port-
channel, gigabitethernet, tengigabitethernet) and
number. Separate nonconsecutive interfaces with a
comma and no spaces; use a hyphen to designate a range
of ports.