Dell POWEREDGE M1000E - Manual (Page 707)

Configuring Port-Based Traffic Control 707
Configuring Priority-Based Flow Control (PCM8024-k Only)
Beginning in Privileged EXEC mode, use the following commands to
configure PFC.
CTRL + Z Exit to Privileged EXEC mode.
show interfaces detail
interface
Display detailed information about the specified interface,
including the flow control status.
show storm-control View whether 802.3x flow control is enabled on the switch.
show storm-control
[ interface | all]
View storm control settings for all interfaces or the
specified interface.
Command Purpose
configure Enter global configuration mode.
interface interface Enter interface configuration mode for the specified
interface. The interface variable includes the interface type
and number, for example gigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface
range ethernet command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
datacenter-bridging Enter the Data Center Bridging mode. PFC commands are
issued from within this mode.
priority-flow-control
mode on
Enable PFC on the interface(s)
priority-flow-control
priority priority-id {drop
| no-drop}
Use the no-drop option to enable the priority group for
lossless behavior. To enable lossy behavior, use the drop
form of the command.
priority-id — Specify the IEEE 802.1p priority value
(range: 0–7)
CTRL + Z Exit to Privileged EXEC mode.
Command Purpose