Dell POWEREDGE M1000E - Manual (Page 430)

430 Monitoring Switch Traffic
sflow rcvr-index polling
if_type if_number poll-
interval
Enable a new sFlow poller instance on an interface range.
• rcvr-index — The sFlow Receiver associated with the
poller (Range: 1–8).
• if_type if_number — The list of interfaces to poll. The
interface type can be Gigabitethernet (gi) or
Tengigabitethernet (te), for example gi1/0/3-5 enables
polling on ports 3, 4, and 5.
• poll-interval — The sFlow instance polling interval. A
value of n means once in n seconds a counter sample is
generated. (Range: 0–86400).
sflow rcvr-index
sampling if_type
if_number sampling-rate
[ size]
Enable a new sflow sampler instance for the specified
interface range.
• rcvr-index — The sFlow Receiver for this sFlow sampler
to which flow samples are to be sent.
• if_type if_number — The list of interfaces to sample. The
interface type can be Gigabitethernet (gi) or
Tengigabitethernet (te), for example gi1/0/3-5 enables
polling on ports 3, 4, and 5.
• sampling-rate — The statistical sampling rate for packet
sampling from this source. A sampling rate of 1 counts all
packets. A value of n means that out of n incoming
packets, 1 packet will be sampled. (Range: 1024 - 65536).
• size — The maximum number of bytes that should be
copied from the sampler packet (Range: 20 - 256 bytes).
interface interface Enter interface configuration mode for the specified
interface. The interface variable includes the interface type
and number, for example gigabitethernet 1/0/3 or gi1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
sflow rcvr-index polling
poll-interval
Enable a new sFlow poller instance for the interface.
sflow rcvr-index sampling
sampling-rate [size]
Enable a new sflow sampler instance for the interface.
Command Purpose