Configuring and viewing dvmrp information, Configuring and viewing dvmrp, Information – Dell POWEREDGE M1000E User Manual
Page 1222
1222
Managing IPv4 and IPv6 Multicast
Configuring and Viewing DVMRP Information
Beginning in Privileged EXEC mode, use the following commands to
configure DVMRP on the switch and on VLAN routing interfaces and to view
DVMRP information.
Command
Purpose
configure
Enter global configuration mode.
ip dvmrp
Enable DVMRP on the switch.
interface vlan
vlan-id
Enter Interface Configuration mode for the specified
VLAN routing interface.
ip dvmrp
Enable DVMRP on the interface.
ip dvmrp metric
metric Configure the metric (range: 1–31) for an interface. This
value is used in the DVMRP messages as the cost to reach
this network.
exit
Exit to Privileged EXEC mode.
show ip dvmrp interface
vlan
vlan-id]
View the multicast information for the specified interface.
show ip dvmrp neighbor View neighbor information for DVMRP.
show ip dvmrp nexthop View the next hop information on outgoing interfaces for
routing multicast datagrams.
show ip dvmrp prune
View the table that lists the router’s upstream prune
information
show ip dvmrp route
View the multicast routing information for DVMRP.