Dell POWEREDGE M1000E - Manual (Page 616)

616 Configuring VLANs
Configuring GVRP
Beginning in Privileged EXEC mode, use the following commands to enable
GVRP on the switch and on an interface, and to configure various GVRP
settings.
protocol group groupid
vlanid
Attach a VLAN ID to the protocol-based group identified
by groupid. A group may only be associated with one
VLAN at a time. However, the VLAN association can be
changed.
• groupid — The protocol-based VLAN group ID, which is
automatically generated when you create a protocol-
based VLAN group with the vlan protocol group
command. To see the group ID associated with the name
of a protocol group, use the show port protocol all
command.
• vlanid — A valid VLAN ID.
CTRL + Z Exit to Privileged EXEC mode.
show port protocol [all|
groupid]
Display the Protocol-Based VLAN information for either
the entire system or for the indicated group.
Command Purpose
configure Enter global configuration mode.
gvrp enable Enable GVRP on the switch.
interface interface Enter interface configuration mode for the specified port
or LAG. The interface variable includes the interface type
and number, for example gigabitethernet 1/0/3 or port-
channel 3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
gvrp enable Enable GVRP on the interface.
Command Purpose