Configuring tunnels – Dell POWEREDGE M1000E User Manual

Page 870

870

Configuring Routing Interfaces

Configuring Tunnels

Beginning in Privileged EXEC mode, use the following commands to

configure a loopback interface.

NOTE:

For information about configuring the IPv6 interface characteristics for a

Command

Purpose

configure

Enter Global Configuration mode.

interface tunnel

tunnel-id Create the tunnel interface and enter Interface

Configuration mode for the specified tunnel.

tunnel mode ipv6ip [6to4] Specify the mode of the tunnel. If you use the 6to4

keyword, the tunnel is an automatic tunnel. If you omit

the keyword, the tunnel is a point-to-point (configured)

tunnel.

ipv6 enable

Enable IPv6 on this interface using the Link Local

address.

tunnel source {

ipv4addr |

vlan

vlan-id}

Specify the source transport address of the tunnel,

either, which can be an IPv4 address or a VLAN routing

interface.

tunnel destination

ipv4addr

Specify the destination transport IPv4 address of the

tunnel.

CTRL + Z

Exit to Privileged EXEC mode.

show interfaces tunnel

[

tunnel-id]

View configuration information for all tunnels or for the

specified tunnel.