Metrohm 796 Titroprocessor - Manual (Page 42)

3.1 Basic settings
796 Titroprocessor, Instructions for use 36 36
The subsequent determinations in the same series
of samples are given the file names DATA006.dtm,
DATA007.dtm
etc.
Please note that only the combination Date+Time
guarantees that a particular file name can never be
used twice.
File
comment type
Mask for automatic creation of file comments for
determination files.
The selection list:
off
no file comment
Remark
only sample remark
Ident1+Meth
sample identification+
method name
Ident1,2+Meth
sample identification+
method name
Ident1,2,3+Meth
sample identification+
method name
Ident1+Remark
sample ident.+ remark
Ident1,2+Remark
etc.
Ident1,2,3+Remark
…
Ident1+Meth+Remark
…
Ident1,2+Meth+Remark
…
The scheme for the automatic creation of file
comments corresponds to that for automatic file
name creation, see above.
Power on
PREP warning
If this warning is switched on this means that
immediately after the Titroprocessor is switched on a
display window appears with a reminder that a
dosing device must be prepared before the start of a
sample series , i.e. the buret must be rinsed with
reagent.
Remote
terminal mode
This mode can be switched on by the remote control
of the Titroprocessor 796 via the RS232 interface. It
has the effect of sending the screen contents with all
character attributes as ANSI control sequences via
the RS232 interface as soon as an alteration to the
screen contents occurs.
File transfer
protocol
For data storage of determination or other files on a
personal computer two different data transfer
protocols are available. If Metrodata 796 backup
software is used then 'Metrohm (Bkup)' should
be selected, otherwise select 'Kermit'. This latter
requires that a PC terminal program is used which
supports this data transfer protocol.