Rockwell Automation 1336S Plus FRN 1.xx-5.xx - Manual (Page 51)

3–3 Human Interface Module
Figure 3.3
HIM Control Panel
Digital Speed
Control and
Indicator
(also available
with Analog
Speed Pot.)
Control Panel Key Descriptions
Start
The Start key will initiate drive operation if no other
control devices are sending a Stop command. This key
can be disabled by the [Logic Mask] or [Start Mask].
Stop
If the drive is running, pressing the Stop key will cause
the drive to stop, using the selected stop mode. Refer to
the [Stop Select 1] and [Stop Select 2] parameters in
Chapter 5.
If the drive has stopped due to a fault, pressing this key
will clear the fault and reset the drive. Refer to the
[Flt Clear Mode], [Logic Mask] and [Fault Mask]
parameters.
Jog
When pressed, jog will be initiated at the frequency set
by the [Jog Frequency] parameter, if no other control
devices are sending a Stop command. Releasing the key
will cause the drive to stop, using the selected stop mode.
Refer to [Stop Select 1], [Stop Select 2], [Logic Mask]
and [Jog Mask].