SATEC PM180 Operation Manual - Manual (Page 49)

‎Chapter 5 Using Telnet Connecting to the Device
PM180 Substation Automation Unit 47
Running the Telnet Client on Windows 2000 and
Windows XP
1. From the Start menu, select Run, type telnet
and click OK.
The following text appears in a window:
Microsoft (R) Windows 2000 (TM) Version 5.00 (Build
2195)
Welcome to Microsoft Telnet Client
Telnet Client Build 5.00.99206.1
Escape Character is 'CTRL+]'
Microsoft Telnet>
2. Type open followed by the device IP address,
for example:
Microsoft Telnet>open 192.168.0.203
Running the Telnet Client on Windows 98
1. From the Start menu, select Run. Type telnet and click OK. The
Telnet Client window is open.
2. In the “Host Name” box, type the device IP address and click OK.
Opening a Telnet Session
When a telnet connection is established, the PM180 Telnet server prints a list of the
available commands as follows:
PM180 Telnet commands
---------------------
h or ? - Display this text
i - Display firmware information
password - Password setting
time [hh:mm:ss] - Time
date [dd/mm/yy] - Date
com[port] - Serial port settings
net - Current Network Addresses
ip - Network settings