SATEC PM135 Quick Start - Manual

BG0517 REV.A1 ENGLISH PM135 QuickStart www.satec-global.com
PM135 Quick Start Manual
This quick start manual is a short guide on how to mount, connect, configure and operate the
PM135. It is not intended to replace reading the full user manual and particularly the safety
precautions.
Mounting, electrical connection and settings of the PM135 shall be made in
accordance with all applicable laws and/or regulations and be performed by
authorized personnel only.
MOUNTING
Position the PM135 meter in 92×92mm square or 4” round cutout (Figure 1). If two PM135 are
positioned side by side, keep at least 150mm (5.9”) between their centers to allow installation
of add-on modules (140mm/5.5” if only small form modules will be used).
Attach the PM135 unit using washers and nuts. Make sure that the unit is securely attached
into the wall or cabinet fixture.
Figure 1
Win a
Tablet!
See back page