SATEC PM180 Operation Manual - Manual (Page 118)

‎Chapter 11 Device Control Remote Relay Control
116 PM180 Substation Automation Unit
Chapter 11 Device Control
This chapter describes how to change device modes, view and clear device
diagnostics, and directly operate relay outputs in your PM180 from PAS. To access
device control options you should have your device online.
Authorization
If your device is password protected (see Access Control Menu in Chapter 3 and
Changing the Password and Security in Chapter 4), you are prompted for the
password when you send your first command to the device.
Enter the password and click OK. If your authorization was successful, you are not
prompted for the password again until you close the dialog window.
Remote Relay Control
From PAS, you can send a command to any relay in your device or release a latched
relay, except of the relays that are linked to the internal pulse source. Such relays
cannot be operated outside of the device.
To enter the Remote Relay Control dialog, check the On-line
button on the PAS
toolbar, select Device Control from the Monitor menu, and then click on the Remote
Relay Control tab.
To send a remote command to the relay:
1. From the “Relay Command” box for the relay, select the desired
command.
2. Click on Send.
The dialog shows you the present relay status and whether it is latched by a remote
command or locally from the setpoint.