SATEC PM180 Operation Manual - Manual (Page 128)

‎Chapter 13 Retrieving Recorded Files Viewing Real-time Waveforms
126 PM180 Substation Automation Unit
Using the Upload Scheduler
To setup the Upload Scheduler:
1. Select Upload Scheduler from the Logs menu.
2. Click Add Site, point to the site database for which you want to
organize the schedule, and then click OK.
3. Click Browse and select a database for storing retrieved data, or
type the name for a new database, select a directory where you
want to save it, and then click OK.
4. Click Configure or double click on the site row.
5. Select a daily, weekly or monthly schedule, and adjust the start
time. If you wish to upload data periodically in predefined intervals,
click on “Periodic” and define the time period in hours and minutes.
6. Select the number of attempts to upload data in the event of
temporary communication problems or unavailability of your
device, and the delay between attempts in minutes and seconds.
7. If you wish to use the schedule to synchronize the device clock
with your PC, check the “RTC Synchronization Enable” box. If your
device is password protected by a communications password, type
in the password you set in the device to allow PAS to update the
clock.
8. Click on the Select Logs button, check the boxes for logs you want
to upload on a schedule, and then click OK.
9. Check the Enabled box at left to activate a schedule for the device.
10. Click OK to store your schedule.
To keep the Upload Scheduler running, the On-line button
on the PAS toolbar
must be checked all the time. If you uncheck it, the scheduler stops operations. This