SATEC PM180 Operation Manual - Manual (Page 12)

‎Chapter 1 Introduction Controls and Indicators
10 PM180 Substation Automation Unit
up to five non-intrusive simultaneous connections, Telnet
service port)

IEEE 802.11b/g backup wireless Ethernet port - WiFi
(MODBUS/TCP, DNP3.0/TCP and IEC 61850 protocols, up
to five non-intrusive simultaneous connections, Telnet service
port)

PROFIBUS DP

IRIG-B for GPS time synchronization
Remote Displays
The PM180 can be ordered with a LED Remote Display Module (RDM180) or an
LCD Remote Graphical Module (RGM180). Both have a fast RS-485 port and
communicate with the PM180 via the MODBUS RTU protocol. Remote displays can
be located at distances of up to 0.5 km from the device. The RGM180 can be
ordered with an Ethernet 10/100Base-T port to communicate with the PM180 over a
local network.
The RDM180 has two four-digit and one six-digit windows with bright red LEDs well
suited for dark areas. It allows the user to view real-time RMS and harmonics
measurements, status indication parameters, and perform basic setup operations
when installing and servicing the device.
The RGM180 is equipped with a TFT color graphics LCD display with Touch Panel
and has extensive dialog capabilities, allowing the user to view different fault and
power quality information in a graphical form, such as waveforms, harmonic
spectrum, phasors and data trends, review latest fault and power quality reports for
fast fault analysis, and much more.
Upgradeable Firmware
The PM180 uses flash memory for storing device firmware. This allows upgrading of
your device without replacing hardware components. New features can be easily
added to your device by simply replacing firmware through any communication port.
Device Models
The expertmeter™ PM180 Series includes two models:
1. Power quality models are available with either
an IEEE 1159 power quality option (standard),
or an EN 50160 (special order) or a
GOST13109 compliance statistics options.
2. Each model option above can be ordered with
Substation Automation System protocol IEC
61850
Firmware Versions
Use the following firmware references to check your device’s options:

V31.X4.XX - Basic fault + IEEE 1159 power quality recorder +
IEC 61000-4-15 flicker

V31.X5.XX - Basic fault + EN 50160 power quality recorder

V31.X7.XX Basic Fault + GOST13109-97 + Flicker IEC
61000-4-15 + Harmonics IEC 61000-4-7

V31.1X.XX +IEC 61850 server option