SATEC SA300 ezPAC Operation Manual - Manual (Page 62)

Chapter 7 Programming the SA300 Basic Device Setup
62 SA300 Substation Automation Unit
The following table lists available options. Refer to your eXpertPower service provider
for the correct eXpertPower settings.
Parameter Options Default Description
XPW Server IP Address 207.232.60.18 The IP address of the
eXpertPower server
XPW Server Port 0-65535 5001 The TCP service port of the
eXpertPower server
XPW Client Enabled NO, YES NO Enables operations of the
eXpertPower client
Time to Next Session, min 1-99999 The time remaining to the
next connection session
NOTES
1. If you do not use the eXpertPower TM service, do not enable the eXpertPower
client in your device.
2. Do not change the connection period setting. The eXpertPower server
updates it automatically.
Basic Device Setup
Before operating your device, define the basic information about your electrical
network.
To enter the setup dialog, select the device site from the list box on the PAS toolbar,
and then select General Setup from the Meter Setup menu.