SATEC SA300 ezPAC Operation Manual - Manual (Page 60)

Chapter 7 Programming the SA300 Changing Port Settings
60 SA300 Substation Automation Unit
Chapter 7 Programming the SA300
This chapter describes how to configure the SA300 for your particular environment
and application using PAS. To access your device configuration options, you should
create a site database for your device as shown in Chapter 6.
Authorization
If the device is password protected (see Access Control Menu in Chapter 3 and
Changing the Password and Security in Chapter 4), you are prompted for the
password when sending the new setup data to the device.
Enter the password and click OK. If your authorization was successful, you are not
prompted for the password again until you close the dialog window.
Changing Port Settings
Setting Up Communication Ports
To enter the setup dialog, select the site from the list box on the PAS toolbar, select
Communications Setup from the Meter Setup menu, and then click on the Serial
Ports Setup tab. In the Port box, select the desired device port.