SATEC SA300 ezPAC Operation Manual - Manual (Page 58)

Chapter 6 Using PAS Setting Up the Device
58 SA300 Substation Automation Unit
3. In the “Protocol” box, select the communications protocol for the
TCP port. PAS automatically adjusts the TCP port number in the
“Host Port” box, corresponding to the selected protocol. Use the
following references to check the TCP port setting:
502 - Modbus RTU
20000 - DNP3.0
4. You can also adjust the amount of time that PAS waits for a
connection before announcing an error and the number of retries
PAS uses to receive a response from the device if
communications fail.
Communicating through a USB
On the Instrument Setup tab, click USB Port, and then click OK.
Setting Up the Device
Creating Setups for the Device
PAS allows you to prepare setup data for your device off-line without the need to
have it connected to your PC.
Select the device site from the list box on the PAS toolbar, and then select the
desired setup group from the Meter Setup menu. Click on the tab with the setup you
want to create or modify and fill in the boxes with the desired configuration data for
your device. Click the “Save as…” button to store the data to the site database.
: Note
Always set up and store the Basic Setup data to the site database first. PAS uses this data as a
reference when arranging other device setup.
To save your setup to another site database, select it from the file pane. Click OK.