SATEC SA300 ezPAC Operation Manual - Manual (Page 52)

Chapter 6 Using PAS Installing the USB Driver
52 SA300 Substation Automation Unit
2. Insert the PAS Installation CD into the CD ROM Drive, select “Install
the software automatically”, and then click “Next”. Windows XP finds
and installs the required driver automatically.
3. Click "Finish" to complete installation.
Windows 2000 and Windows 98 Installation
1. On Windows 2000, the "Found New Hardware Wizard" dialog box is
displayed as shown below. On Windows 98, the similar "Add New
Hardware Wizard" dialog box is displayed.
2. Click "Next" to continue.