Lenze Global Drive PLC Developer Studio - Manual (Page 2)

This Manual applies to the following Lenze PLCs:
Type From hardware version From software version
Drive PLC EPL10200 Px 8.0
What’s new?
Version Changes
1.1 07/2000 Revised edition for Drive PLCs as of software version V1.0
2.1 07/2001 Revised edition for Drive PLCs as of software version V2.0
3.0 01/2003 Revised edition for Drive PLCs as of software version V6.0
4.0 03/2005 Revised edition for Drive PLCs as of software version V7.0
5.0 12/2007 Revised edition for Drive PLCs as of software version V8.0
6.0 09/2013 General corrections
Important note :
The software is supplied to the user as described in this document. Any risks resulting from its quality or use remain the responsibility of the
user. The user must provide all safety measures protecting against possible maloperation.
We do not take any liability for direct or indirect damage, e.g. profit loss, order loss or any loss regarding business.
ã 2013 Lenze Automation GmbH
No part of this documentation may be copied or made available to third parties without the explicit written approval of Lenze Automation GmbH.
All information given in this documentation has been carefully selected and tested for compliance with the hardware and software described.
Nevertheless, discrepancies cannot be ruled out. We do not accept any responsibility or liability for any damage that may occur. Required
correction will be included in updates of this documentation.
All product names mentioned in this documentation are trademarks of the corresponding owners.
Version 6.0 09/2013