Seiwa SW701i SW701e - Manual (Page 73)

75 User Manual
Inhibit Navigation operation
As soon as Slave mode is set, the Destination cannot be placed anymore either
the C-Link Navigation Data is received from the Master or not. Also, when the
C-Link Navigation Data is received from the Master, it will not be allowed to deac-
tivate the Navigation.
Inhibit Route following
While navigating to the route received from the Master and the Destination is
reached the Destination will be moved to the next Waypoint on the route.
MOB handling
If the Navigation to the external Destination is active and [MOB] is pressed on
the Slave chart plotter, the MOB is placed but the navigation to the MOB is not
activated.
Note While navigating to the external Destination the operating mode is switched
to Master, the navigation to the external Destination will be terminated.
C-LINK NAVIGATION DATA: ACQUISITION AND DISPLAY
As soon as the C-Link Navigation Data is received, the Slave parses the information
received and executes the relative actions depending on its current working status.
Note When the Navigation to the external Destination is activated, the Slave Chart
Plotter will show all relevant C-Link Navigation Data exactly like when the
Destination is not the external one (Destination Name, DST and BRG to
Destination, calculate XTE, calculate TTG etc). These values will be displayed all
places where required and they will be used to format NMEA-0183 output data.
GRAPHICAL REPRESENTATION ON MAP DISPLAY
Fig. 4.3 - Graphical Displaying
ROUTE DATA REPORT
On the Slave chart plotter, when the navigation to the External route is received,
it is possible to display the information related to the External route by entering
the Route Data Report:
[MENU] + "Route" + [ENTER] + "Report" + [ENTER]
SW1101:
[DATA] + "Route" + [ENTER] + "Reporto" + [ENTER]