Seiwa SW701i SW701e - Manual (Page 72)

74 User Manual
The information sent by the Master consists of the following values:
♦
Navigation mode (To Single Destination/to a Route)
♦
Route Name*
♦
Destination ID
♦
Destination Position
♦
Next Waypoint ID*
♦
Range from Destination to next Waypoint*
♦
Bearing from Destination to next Waypoint*
♦
Route Length*
♦
Distance from Destination to Last Route Waypoint*
♦
Remaining Route Legs*
♦
Planned Cruising Speed
♦
Average Fuel Consumption
♦
Initial Fuel Load
Values identified by * are sent only for Route Following navigation.
The Destination Icon, Navigation leg (Fix Position to Destination), the Next Waypoint
Icon and all other relevant C-Link Navigation Data will be shown on the Slave
chart plotter. Any variation of the C-Link Navigation Data on the Master will be
communicated to the Slave so to keep data aligned on both devices.
MASTER CHART PLOTTER
Operating mode
To select the Master mode follow the procedure:
[MENU] + "Advanced Options" + [ENTER] + "C-Link" + [ENTER] + "Primary
Station" + [ENTER]
Master mode is the default factory setting. All regular chart plotters functions are
allowed. As soon as the Destination is placed, the Master chart plotter will start
transmitting all C-Link Navigation Data.
In Master mode the C-Link Navigation Data received from the NMEA port is ig-
nored. So, if the two chart plotters are both operating in Master mode, the C-Link
Navigation Data sent by the other chart plotter never processed.
Under such condition if the navigation is activated on one of the two chart plot-
ters, a warning message will be shown to notify that the C-Link navigation data
will be ignored by the other chart plotter.
SLAVE CHART PLOTTER
Operating mode
To select the Slave mode follow the procedure:
[MENU] + "Advanced Options" + [ENTER] + "C-Link" + [ENTER] + "Secondary
Station" + [ENTER]
When Slave mode is set, the chart plotter cannot manipulate the C-Link Naviga-
tion Data anymore.
It is necessary to disable the Internal GPS on the Slave chart plotter before start
to work with the C-Link system:
[MENU] + "Advanced Options" + [ENTER] + "Input/Output" + [ENTER] +
"GPS Configuration" + [ENTER] + "GPS Antenna" + [ENTER] + "No" +
[ENTER]
Stop current navigation
If the navigation was already active, it will be disabled as soon as Slave mode is
set. An appropriate warning message will be shown to notify that the Navigation
is already active and to confirm whether Slave mode can be set.