Seiwa SW701i SW701e - Manual (Page 31)

33 User Manual
[MENU] + "User Points" + [ENTER] + "List" + [ENTER] + [Route] 1 + use the
cursor key to highlight the Route + [Select] 1
SW1101:
[DATA] + "User Points" + [ENTER] + "List" + [ENTER] + [Route] + use the
cursor key to highlight the Route + [Select]
It is possible to link the User Point to the selected Route. If the selected User Point
is already linked to the Route, the same procedure is used to disconnect it from
Route:
[MENU] + "User Points" + [ENTER] + "List" + [ENTER] + [Route+] 2
NOTE 1 F
OR SEAWAVE 3 , press [2, Route] and [ENTER].
NOTE 2 F
OR SEAWAVE 3 , press [3, Route+].
SW1101:
[DATA] + "User Points" + [ENTER] + "List" + [ENTER] + [Route+]
2.2 ROUTES
A Route is made by placing a series of Waypoints or by linking existing Marks.
Among the available Routes only one can be the Active Route, that is shown on
the screen by straight lines and arrows to indicate the direction; the first Waypoint
of this Route is surrounded by a circle. The Active Route (sometimes called cur-
rent) is the working Route: it can be edited by adding, removing or moving
Waypoints.
Selecting Active Route
[MENU] + "Route" + [ENTER] + "Select" + [ENTER] + use the cursor key to
highlight the Route + [Select] 1
NOTE 1 F
OR SEAWAVE 3 , press [ENTER].
SW1101:
[DATA] + "Route" + [ENTER] + "Select" + [ENTER] + use the cursor key to
highlight the Route + [Select]
The Route, shown by straight segments, is centered on the screen, with the cur-
sor on the central Waypoint. This will then allow you to quickly work out which
Route you have selected.
When you want to create a new Route, select an open Route position in the list
using the above procedure.
Creating a Route
To create a new Route:
Place the cursor + [ENTER] + "WAYPOINT" + [ENTER]
MARLIN:
Place the cursor + [ROUTE]
This places the first Waypoint of the new Route on your cursor position. If a Mark
is present under the cursor position, the Mark is linked to the Route. To place the
next Waypoints of the Route repeat the above procedure.
The following functions work on the Active Route.
Inserting notes on Route
To insert a comment on the selected Route:
[MENU] + "Route" + [ENTER] + "Select" + [ENTER] + use the cursor key to
highlight the Route + [Notes] 1
NOTE 1 F
OR SEAWAVE 3 , press [1, Notes].