Seiwa SW701i SW701e - Manual (Page 19)

21 User Manual
The table shows all the characters usable. Use the cursor key to go through the
available characters and select the requested one. The four soft keys are now
activated to:
♦
[Save] : to save when the entry is complete. After pressing [Save] the
Soft Keys disappear: press [Accept] to end the input procedure
♦
[Change] : to switch between numeric/non-numeric digits
♦
[Previous]: to go back to previous page
♦
[Next] : to move to next page
Only For SEAWAVE 3 :
The following virtual keys on the visual keyboard are now activated to:
♦
[%&#] : to switch between numeric/non-numeric digits
♦
[<-] : to go back to previous digit
♦
[->] : to move to next digit
♦
[Enter] : to save when the entry is complete.
Press [1, Accept] to end the input procedure
1.2 SWITCHING ON/OFF
Before powering On the chart plotter, check for the correct voltage (10-35 volt
dc) and the correct connections with the positioning instrument.
Switching On
[POWER] for 1 second
In the opening page, underneath the Seiwa logo, you will find the software ver-
sion and type. The next page is the First Setup page (see Par. 1.3) which is
activated only when the chart plotter is turned on for the first time and after a
Master reset. Then the chart plotter will automatically show the Jeppesen warning
page and the GPS Status page. Pressing [CLEAR] at this stage to activate the
cartography page.
Switching Off
[POWER] for 3 seconds
A countdown timer appears on the screen, if you release the key before the
countdown timer reaches zero, the chart plotter will remain On.
EXPLORER 3 :
NOTE The default resolution is 800x600 (manufactory condition or after a CLEAR
RAM operation). If connected to a monitor without a different resolution, it is
possible that the image is not shown. So you should set the proper resolution
for the monitor in use (see the monitor manual and the Par. 6.1.7).
1.3 FIRST SETUP PAGE
This menu allows you to configure the chart plotter and the external devices the
first time the chart plotter is powered On. This information can be changed at any
time either from the General Options menu (see Par. 3.1) or by resetting the chart
plotter. Select the correct setup option and press [ENTER], when complete press
[OK] 1 to exit.
NOTE 1 F
OR SEAWAVE 3 , press [1, OK].