Festo Кабели и принадлежности - Manual (Page 8)

Contents and general instructions
VI
Festo P.BE−SPC200−COM−CANDN−EN en 0511a
Target group
This manual is intended exclusively for technicians trained in
control and automation technology, who have experience in
installing, commissioning, programming and diagnosing
DeviceNet slaves.
Service
Please consult your local Festo repair service if you have any
technical problems.
Notes on software versions
Please note
The field bus module type SPC200−COM−DN2 requires:
Ĉ an SPC200 with firmware as from version 4.9,
Ĉ the WinPISA software as from version 4.5.
Overview:
Field bus module Version WinPISA SPC200 firmware
SPC200−COM−CAN V1.0 as from 4.1 as from 3.8
V 1.2 as from 4.31 as from 4.63
SPC200−COM−DN2 V 2.01 as from 4.5 as from 4.9