Allied Telesis AT-S39 - Manual (Page 89)

AT-S39 User’s Guide
89
Creating a Port Trunk
This section contains the procedure for creating a port trunk on the
switch. Be sure to review the guidelines in Port Trunking Overview on
page 83 before performing the procedure.
Caution
Do not connect the cables to the trunk ports on the switches until
after you have configured the trunk with the management
software. Connecting the cables before configuring the software
will create a loop in your network topology. Data loops can result in
broadcast storms and poor network performance.
Note
Before creating a port trunk, examine the parameter settings of the
ports that will make up the trunk. Check to be sure that the settings,
such as speed and duplex mode, are the same for all the ports of the
trunk. You should also check to be sure that the ports are members
of the same VLAN.
To create a port trunk, perform the following procedure:
1. From the Main Menu, type 1 to select Port Menu.
2. From the Port Menu, type 3 to select Port Trunking.
The Port Trunking menu in Figure 21 is displayed.
Figure 21 Port Trunking Menu
Allied Telesyn Ethernet Switch AT-8024
Login Privilege: Manager
Port Trunking
1 - Trunk Ports ..... None
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection?