Allied Telesis AT-S39 - Manual (Page 224)

Section II: Local and Telnet Management
224
The following prompt is displayed:
Enter the starting remote switch number -> [1 to 12]
4. Enter the number of the switch whose software or configuration file
you want to update. To update a range of switches, enter the number
of the first switch.
The following prompt is displayed:
Enter the ending remote switch number -> [1 to 12]
5. Enter the last switch in the range you want to update. To update just
one switch, enter the same number here as you entered in the
previous step.
The following prompt is displayed:
Do you want to show remote switch burning flash ->
[Yes/No]
6. You can respond with Yes or No to this prompt. It does not affect the
download.
The following prompt is displayed:
Do you want confirmation before downloading each
switch -> [Yes/No]
7. Answering Yes to this prompt means that the management software
will prompt you with a confirmation message before it begins to
upgrade each switch. Answering No means the management
software will not display a confirmation prompt before downloading.
The management software begins the download. The
management software notifies you when the download is
complete.
Caution
Once a switch image file has been downloaded, the switch must
decompress it and write it to flash. This can require one to two
minutes to complete. Do not reset or power off the unit while it is
decompressing the file. Once the file has been decompressed, the
switch automatically resets.