Allied Telesis AT-S39 - Manual (Page 44)

Section II: Local and Telnet Management
44
Configuring SNMP Community Strings and Trap IP Addresses
To configure the SNMP community strings for the switch and to assign
up to four IP addresses of management stations to receive traps from
the switch, perform the following procedure:
Note
SNMP access is disabled by default. To enable SNMP access, refer to
Configuring Management Access on page 51.
1. From the Main Menu, type 5 to select System Config Menu.
The System Configuration Menu in Figure 4 is displayed.
Figure 4 System Configuration Menu
Allied Telesyn AT-8024 Ethernet Switch
Login Privilege: Manager
System Config Menu
1 - MAC Aging Time .................... 300 seconds
2 - Switch Mode ....................... Tagged
3 - Console Disconnect Timer Interval . 10 minute(s)
4 - Web Server Status ................. Enabled
5 - SNMP Access ....................... Disabled
6 - Console Startup Mode .............. Menu
7 - BALUN Cable Detection ............. Disabled
8 - Reset to Factory Defaults
A - Advanced Configuration
R - Return to Previous Menu
Enter your selection?