Allied Telesis AT-S39 - Manual (Page 195)

AT-S39 User’s Guide
195
Configuring an Authentication Method
To enable or disable the server-based authentication feature on the
switch and to configure the TACACS+ and RADIUS settings, perform the
following procedure:
1. From the Main Menu, type 4 to select Administration Menu.
2. From the Administration Menu, type A to select Server-based
Authentication.
The Authentication Menu in Figure 50 is displayed.
Figure 50 Authentication Menu
3. To enable or disable the authentication feature on the switch, type 1
to select Server-based Authentication. The following prompt is
displayed:
Server Based User Authentication (E-Enabled, D-
Disabled) ->
4. Type E to enable the TACACS+ and RADIUS protocols on the switch or
D to disable them. The default is disabled.
If you enable the authentication feature, continue to the next
step. If you disabled it, type S to save your change. You can now
return to the Main Menu.
5. To select an authentication protocol, type 2 to select Authentication
Method. The following prompt is displayed:
Enter T-TACACS+, R-RADIUS ->
6. Type T to select TACACS+ or R for RADIUS. The default is TACACS+.
Only one protocol can be active on the switch at a time.
Allied Telesyn Ethernet Switch AT-8024
Login Privilege: Manager
Authentication Menu
1 - Server-based Authentication ..... Disabled
2 - Authentication Method ........... TACACS+
3 - TACACS+ Configuration
4 - RADIUS Configuration
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection?