Allied Telesis AT-S39 - Manual (Page 203)

AT-S39 User’s Guide
203
Enabling and Disabling Port Access Control
To globally enable or disable Port Access Control, perform the following
procedure:
Note
Enabling or disabling Port Access Control can only be performed in
a local management session.
Note
Before activating this feature, you must have the RADIUS EAP
specified and enabled as the authenication method. This is
discussed in Configuring an Authentication Method on page 195.
1. From the Main Menu, type 1 to select Port Menu (shown in Figure 54).
2. Type 6 to select Port Access Control (shown in Figure 54).
Figure 54 Port Access Control Menu
3. Type 1 to select Port Access Control. The following prompt is
displayed:
Port Access Control (E-Enable, D-Disable) :
4. Type E to enable port access control, or D to disable port access
control. Press Return.
5. Type S to select Save Configuration Changes.
Allied Telesyn Ethernet Switch AT-8024
Login Privilege: Manager
Port Access Control
1 - Port Access Control .............. Enabled
2 - Authentication Method ............ RADIUS EAP
3 - Configure Port Access Parameters
4 - Display Port Access Parameters
5 - Display Port Access Status
S - Save Configuration changes
R - Return to Previous Menu
Enter your selection?