Allied Telesis AT-S39 - Manual (Page 197)

AT-S39 User’s Guide
197
Enter per-server secret [max 40 characters] ->
Use this prompt to enter the encryption secret for the
TACACS+ server whose IP address you are specifying.
4 - TAC Server Order
You use this selection to indicate the order in which you want
the switch to query the TACACS+ servers for logon
authentication. Of course, you can skip this option if you
specified only one IP address. The default is 1, 2, and 3, in that
order.
5 - TAC Global Secret
If all of the TACACS+ servers have the same encryption secret,
rather then entering the same secret when you enter the IP
addresses, you can use this option to enter the secret just
once.
3 - TAC Timeout
This parameter specifies the maximum amount of time the
switch waits for a response from a TACACS+ server before
assuming the server cannot respond. If the timeout expires
and the server has not responded, the switch queries the next
TACACS+ server in the list. If there aren’t any more servers, the
switch defaults to the standard Manager and Operator
accounts. The default is 30 seconds. The range is 1 to 30
seconds.
c. After you have finished configuring the parameters, type S to
select Save Configuration Changes.
8. To configure the RADIUS protocol, from the Authentication Menu in
Figure 50 on page 195 do the following:
a. Type 4 to select RADIUS Configuration.