Allied Telesis AT-S39 - Manual (Page 112)

Section II: Local and Telnet Management
112
6 - Bridge Identifier
The MAC address of the bridge. The bridge identifier is used as a
tie breaker in the selection of the root bridge when two or more
bridges have the same bridge priority value. This value cannot be
changed.
3. After adjusting the parameters, type S to select Save Configuration
Changes.
Configuring a
Port’s RSTP
Settings
To adjust a port’s RSTP parameters, perform the following procedure:
1. From the Spanning Tree Menu, type 4 to select RSTP Configuration.
2. From the RSTP Configuration menu, type P to select RSTP Port
Parameters.
The following menu is displayed:
Figure 31 RSTP Port Parameters
3. Type 1 to select Configure RSTP Port Settings.
The following prompt is displayed:
Starting Port to Configure [1 to 24] ->
4. Enter the number of the port you want to configure. To configure a
range of ports, enter the first port of the range.
The following prompt is displayed:
Ending Port to Configure [1 to 24] ->
5. To configure just one port, enter the same port number here as you
entered in the previous step. To configure a range of ports, enter the
last port of the range.
Allied Telesyn Ethernet Switch AT-8024
Login Privilege: Manager
RSTP Port Parameters
The current protocol version is RSTP.
1 - Configure RSTP Port Settings
2 - Display RSTP Port Configuration
3 - Display RSTP Port State
S - Save Configuration changes
R - Return to Previous Menu
Enter your selection?