Allied Telesis AT-S39 - Manual (Page 310)

Section III: Web Browser Management
310
IP Address and Encryption Secret
Use these fields to specify the IP addresses and encryption
secrets of up to three network servers containing
TACACS+ server software. You can leave an encryption
field blank if you entered the server’s secret in the Global
Secret field.
c. After you have finished configuring the parameters, click Apply.
8. To configure RADIUS, do the following:
a. From the Server-based Authentication tab, click the check
circle next to RADIUS Configuration and click Configure.
The RADIUS Configuration menu in Figure 98 is displayed.
Figure 99 RADIUS Configuration
b. Configure the parameters as needed. They are described
below.
Global Encryption Key
If all of the TACACS+ servers have the same encryption
secret, you can enter the key here. If the servers have
different keys, you must specify each key when you specify
a server’s IP address.
Global Server Timeout
This parameter specifies the maximum amount of time the
switch will wait for a response from a TACACS+ server
before assuming the server cannot respond. If the timeout
expires and the server has not responded, the switch