Allied Telesis AT-S39 - Manual (Page 262)

Section III: Web Browser Management
262
4. To create a port trunk, do the following:
a. Click the ports that will make up the port trunk. A selected port
changes to white. An unselected port is black. A port trunk can
contain 2, 3, or 4 ports.
b. Click Apply.
Once you have selected the ports of the trunk, the following
appear under Trunk Method.
c. Click the desired load distribution method. The default is SA/DA.
d. Configure the ports on the remote switch for port trunking.
The new port trunk is immediately activated on the switch. You
can now connect the data cables to the ports of the trunk on the
switch.
5. To delete a port trunk, click Remove. The port trunk is immediately
deleted from the switch.