Allied Telesis AT-S39 - Manual (Page 164)

Section II: Local and Telnet Management
164
Displaying MAC Addresses
The management software has two menu selections for displaying the
MAC addresses of a switch. One selection displays the static, dynamic,
and multicast MAC addresses while the other displays just the static and
multicast addresses, but no dynamic addresses.
To display the MAC address table, perform the following procedure:
1. From the Main Menu, type 6 to select MAC Address Tables.
The MAC Address Table menu in Figure 44 is displayed.
Figure 44 MAC Address Table Menu
2. To display both static and dynamic MAC addresses, type 1 to select
Show All MAC Addresses or A to select View MAC Addresses on Base
Ports. The second selection is useful if you are managing an AT-8000
Series switch with GBIC or expansion modules installed, and you want
to view the MAC addresses only on Ports 1 to 24.
3. To display only static MAC addresses, type 5 to select Show All Static
MAC Addresses.
Allied Telesyn AT-8024 Ethernet Switch
Login Privilege: Manager
MAC Address Tables
1 - Show all MAC Addresses
2 - Add static MAC Address
3 - Delete MAC Address
4 - Delete all dynamic MAC Addresses
5 - Show all static MAC addresses
6 - View MAC addresses by Port
7 - View the port of MAC address
8 - View MAC addresses by VLAN ID
9 - View IP Multicast MAC Addresses
A - View MAC addresses on base ports
R - Return to Previous Menu
Enter your selection?