Allied Telesis AT-S39 - Manual (Page 243)

AT-S39 User’s Guide
243
Returning the AT-S39 Software to the Factory Default Values
The procedure in this section returns all AT-S39 software parameters,
except the IP address, subnet mask, and gateway address, to their
default values. This procedure also deletes any VLANs that you have
created on the switch.
Note
The AT-S39 software default values can be found in Appendix A,
AT-S39 Default Settings on page 312.
To return the AT-S39 management software to its default settings,
perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the System menu option.
3. Select the Factory Default tab.
The Factory Default tab in Figure 71 is displayed.
Figure 71 Factory Default Tab
4. Click the check box next to Reset Switch.
5. Click Apply.
6. Follow the prompts.